Delfield NDF-18 Manuel d'installation Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 20
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
Milk, Ice Cream & Milk & Ice Cream Dispensers Service and Installation Manual
For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delfield.com
2
Serial Number Location .............................................................2
Receiving and Inspecting Equipment ........................................2
Specifications .............................................................................3
Installation ...............................................................................4-5
Operation ....................................................................................6
Maintenance ...............................................................................7
Wiring Diagram ..........................................................................8
Replacement Parts ................................................................9-16
Standard Labor Guidelines ......................................................17
Standard Warranties ...........................................................18-19
Serial number tag locations
MF/MFSC, FF/FFSC and RFF/RFFSC on the end above the
refrigeration system.
N, N6/N10/N14, and SCF — rear of the unit above the louver.
NDF — Front right hand corner under the lid.
NLFAC — at the rear of the unit by the power cord.
Always have the serial number of your unit available when calling
for parts or service. A complete list of authorized Delfield parts
depots is available at www.delfield.com.
The units represented in this manual are for indoor use only.
©2010 The Delfield Company. All rights reserved. Reproduction without
written permission is prohibited. “Delfield” and “Shelleymatic” are registered
trademarks of The Delfield Company.
Contents
Serial Number Location
Receiving and Inspecting the Equipment
Even though most equipment is shipped crated, care should
be taken during unloading so the equipment is not damaged
while being moved into the building.
1. Visually inspect the exterior of the package and skid or
container. Any damage should be noted and reported to
the delivering carrier immediately.
2. If damaged, open and inspect the contents with the
carrier.
3. In the event that the exterior is not damaged, yet upon
opening, there is concealed damage to the equipment
notify the carrier. Notification should be made verbally
as well as in written form.
4. Request an inspection by the shipping company of the
damaged equipment. This should be done within 10
days from receipt of the equipment.
5. Check the lower portion of the unit to be sure casters are
not bent.
6. Also open the compressor compartment housing and
visually inspect the refrigeration package. Be sure lines
are secure and base is still intact.
7. Freight carriers can supply the necessary damage forms
upon request.
8. Retain all crating material until an inspection has been
made or waived.
Uncrating the Equipment
First cut and remove the banding from around the crate.
Remove the front of the crate material, use of some tools will
be required. If the unit is on legs remove the top of the crate
as well and lift the unit off the skid. If the unit is on casters it
can be rolled off the skid.
Vue de la page 1
1 2 3 4 5 6 7 ... 19 20

Commentaires sur ces manuels

Pas de commentaire