Delfield NDF-18 Manuel d'installation télécharger pdf (Page 4)

Milk, Ice Cream & Milk & Ice Cream Dispensers Service and Installation Manual

For customer service, call (800) 733-8829, (800) 773-8821, Fax (989) 773-3210, www.delﬁeld.com

Location

These units are intended for indoor use only. Be sure the location

chosen has a floor strong enough to support the total weight of

the cabinet and contents. Units in this product line can weigh as

much as 1500 pounds when it is fully stocked. Reinforce the

floor as necessary to provide for maximum loading.

For the most efficient refrigeration, be sure to provide good air

circulation inside and out.

Inside cabinet: Do not pack unit so full that air cannot circulate.

Take care not to block air flow to the fans and allow space along

sides.

Outside cabinet: Be sure that the unit has access to ample

air. Avoid hot corners and locations near stoves and ovens. It

is recommended that the rear of the unit be no less than two

inches from any wall, partition or any other object which will

restrict exhaust air flow.

Leveling

A level cabinet looks better and will perform better because

the cabinet will not be subject to unnecessary strain due to

doors not properly lining up with door frames.

Some models have casters for ease of cleaning underneath and

for mobility. It is important that the unit be installed in a stable

condition with the front casters locked before operating. Locking

the front casters after installation is the operator’s responsibility.

Electrical connection

A standard self-contained unit is provided with a power cord

and three-prong grounded plug.

The unit should be plugged into a receptacle with its own

circuit protection that matches the amperage of the plug.

Refer to the amperage data on page three or the

serial tag data and your local code or the National

Electrical Code to be sure the unit is connected

to the proper power source. A protected circuit of

the correct voltage and amperage must be run for

connection to the unit.

The power supply must be disconnected

whenever performing maintenance or repairing

the equipment!

The unit must never be operated without the

louvered panel in place.

Built-in units

All self-contained units (MFSC, FFSC and RFFSC) are tested at

the factory to assure proper operation. The unit should not be

installed directly next to high heat generating equipment (ranges,

griddles, etc.).

These units are built into the counter from below and must be

supported from the bottom. The counter cut-out sizes and power

supply requirements are shown in the specifications on page

three. All refrigerators have drains located in the bottom of the

tank. An appropriate drainage area or container must be provided

by the customer. Be sure to place the unit so the pressure control,

located near the compressor, can be reached.

For installation of remote units (MF, FF and RFF), consult a

refrigeration service company to connect refrigeration lines to the

remote condensing unit.

Self-contained refrigerated units (MFSC, FFSC and

RFFSC) require air flow to the compressor. A louver

is provided and must be installed in the counter in

front of the condenser. An equal size opening at the

rear of the cabinet must also be provided to allow

warm air to escape. Failure to do so will void all

product warranties.

Free standing units

All self-contained units (N, N6/10/14, NDF, NLFAC, SCF and

NSCF) are tested at the factory to assure proper operation. The

unit should not be installed directly next to high heat generating

equipment (ranges, griddles, etc.).

These units are free standing, either on legs or casters. The

power supply requirements are shown on page three. All free

standing units have drains located in the bottom of the tank.

An appropriate drainage area or container must be provided by

the customer.

Do not place the unit against a wall or any object that will block

air circulation through the condensing unit. If the unit must

be placed against a wall, leave a minimum of 2” of space for

air flow.

Installation

1 2 3 4 5 6 7 8 9 ... 19 20

Commentaires sur ces manuels

Pas de commentaire

Delfield NDF-18 Manuel d'installation Page 4

Commentaires sur ces manuels

Produits connexes et manuels pour Distributeurs d'eau Delfield NDF-18